The Bumble & Goose Guide
How to Build a Brownie Stack
No glue, no wire, no mess. A properly built stack holds its own shape, here’s exactly how to do it in about ten minutes.
A brownie stack is a tiered tower of bite-sized brownies, built up from a wide base to a narrow top, used as a centrepiece for weddings, birthdays and corporate events. Most brownie towers are held together with melted chocolate or icing acting as an edible glue, which means they arrive pre-assembled, fragile, and often local-collection only.
Bumble & Goose brownie stacks work differently. Your bites arrive bagged in small stacks of two to four, always an even number, so nothing is stuck together until you decide where it goes. You build the stack fresh, wherever you’re serving it. No glue needed, if it’s built right, the weight and overlap of the bites hold everything in place on their own.
Before You Start
Keep your bites in the fridge until you’re ready to build. Chilled brownies are firmer and much easier to unpack and stack neatly, and they’ll hold their shape better once arranged. Give yourself a clear, flat surface and your chosen cake stand or board, and count out your bites before you begin so you’re not searching mid-build.
Five Steps to Build Your Stack
1. Unwrap and sort your bites
Unbag all your bites and lay them out. If you’ve ordered a flavour mix, sorting them into groups now makes it easier to distribute flavours evenly through the stack rather than clumping one flavour on one side.
2. Work out your three layers
Split your total bites roughly 40% for the base, 35% for the middle, and 25% for the top. This gives you a stable, wide foundation and a natural taper rather than a straight-sided tower. See the table below for exact numbers by stack size.
3. Build the base layer
Arrange your base bites flat on the stand or board in a tight circle or square, edges slightly overlapping. This layer carries the weight of everything above it, so take a little extra care getting it even and stable before moving on.
4. Add the middle and top layers
Stack the middle layer inward from the edge of the base, so each bite has some support underneath it rather than overhanging. Repeat for the top layer, finishing with a slight peak rather than a flat top for the classic stacked look. Because the bites are small and light, no glue or icing is needed, the overlap and weight distribution hold it together.
5. Add a finishing touch, if you’d like one
Every brownie is made with proper chocolate and quality ingredients, so the stack doesn’t need decoration to look the part. If you’d like to make it your own, fresh strawberries or pretzels tucked between the layers add colour and a nice finishing touch, or a few crushed Oreos or a warm white chocolate caramel sauce drizzled over the top. All entirely optional.
Layer Breakdown by Stack Size
Use this as a starting guide for step 2, based on a 40% base, 35% middle, 25% top split.
| Total Bites | Base Layer | Middle Layer | Top Layer |
|---|---|---|---|
| 12 | 5 bites | 4 bites | 3 bites |
| 24 | 10 bites | 8 bites | 6 bites |
| 40 | 16 bites | 14 bites | 10 bites |
| 60 | 24 bites | 21 bites | 15 bites |
| 80 | 32 bites | 28 bites | 20 bites |
| 100 | 40 bites | 35 bites | 25 bites |
| 120 | 48 bites | 42 bites | 30 bites |
| 160 | 64 bites | 56 bites | 40 bites |
Ordering more than 160 bites? For very large stacks, building it as two or more stacks side by side is often more stable than one very tall tower.
A Few Extra Tips
- Chill your bites right up until you’re ready to build, warm brownies are softer and more likely to slide.
- Build on the stand or board it will actually be served on, moving a finished stack risks it shifting.
- If you’d like extra stability for a taller stack, plain wooden cocktail sticks tucked between layers work well, just remove them before serving.
- Build as close to serving time as you reasonably can, ideally within a couple of hours, for the freshest look and taste.
- If a bite doesn’t sit flat, turn it over, the flatter side usually gives a steadier base.
Brownie Stack Building Questions
Do I need glue to build a brownie stack?
No. Some brownie towers use melted chocolate or icing as an edible glue, but a properly built stack made from small, light bites holds its shape through overlap and weight alone, no adhesive needed.
How long does it take to build a brownie stack?
Around ten minutes for most sizes, once your bites are chilled and sorted. Larger stacks of 100 bites or more may take a little longer.
Can I build the stack the night before?
It’s best built as close to serving time as possible, ideally within a couple of hours, for the freshest look. If you do need to build early, keep it somewhere cool and avoid moving it once assembled.
What if my stack starts to lean or a bite won’t sit flat?
Try turning the bite over, the flatter cut side usually gives a steadier base. If a whole section feels unstable, a plain wooden cocktail stick tucked between layers adds extra support, just remove it before serving.
Do I need to add toppings or decoration?
No, the brownies are made with quality chocolate and ingredients, so they don’t need sauces or decoration to look impressive. Fresh strawberries, pretzels, or a warm white chocolate caramel sauce are popular optional additions.
What stand or board should I build on?
Any flat cake stand or board works well, a tall glass pedestal, a rustic wooden stand, or a tiered gold stand all suit a brownie stack. Build directly on the stand you’ll be serving from, rather than assembling elsewhere and moving it.